Knots/Bend knots/Water knot

Water knot Water-knot-webbing-tight-ABOK-296.jpg Tape knot, Ring bend, Grass knot, Overhand follow through bend Overhand knot, Beer knot, Overhand bend To join webbing for climbing Ends should be left long, knot should be tightened and inspected before each use. Difficult to untie. #296 The water knot (also tape knot, ring bend, grass knot, or overhand follow-through) is a knot frequently used in climbing for joining two ends of webbing together, for instance when making a sling. Tying the water knot thumb|left|Water knot before tightening It is tied by forming an overhand knot in one end and then following it with the other end, feeding in the opposite direction. The ends should be left at least 3 inches 8cm long and the knot should be "set" by tightening it with full body weight. The ends can be taped or lightly sewn to the standing parts to help prevent them from creeping back into the knot.Craig Luebben, Knots for Climbers (Evergreen, Colorado: Chockstone Press, 1993), 19. Security Testing has shown the water knot to slip very slightly, but very consistently, with each load and unload cycle. In tests using 9/16 in 14.3 mm tubular webbing, repeated loading and unloading with 250 lbs 113 kg caused one of the 3 in 76 mm tails to work back into the knot in just over 800 loading cycles. When the water knot was statically loaded with 200 lbs 91 kg no slipping was observed. These results validate the need to leave long tails and inspect water knots before each use.Tom Moyer, Water Knot Testing, 1999 International Technical Rescue Symposium, 1999. ( accessed 2007-04-07.) References