FCC Technician Class Exam Study Guide - 2014-2018/Subelement T4 Group B

Operating controls: tuning; use of filters; squelch function; AGC; repeater offset; memory channels The Question Pool Question 1 What may happen if a transmitter is operated with the microphone gain set too high? A. The output power might be too high B. The output signal might become distorted C. The frequency might vary D. The SWR might increase The correct answer is B. Question 2 Which of the following can be used to enter the operating frequency on a modern transceiver? A. The keypad or VFO knob B. The CTCSS or DTMF encoder C. The Automatic Frequency Control D. All of these choices are correct The correct answer is A. Question 3 What is the purpose of the squelch control on a transceiver? A. To set the highest level of volume desired B. To set the transmitter power level C. To adjust the automatic gain control D. To mute receiver output noise when no signal is being received The correct answer is D. Question 4 What is a way to enable quick access to a favorite frequency on your transceiver? A. Enable the CTCSS tones B. Store the frequency in a memory channel C. Disable the CTCSS tones D. Use the scan mode to select the desired frequency The correct answer is B. Question 5 Which of the following would reduce ignition interference to a receiver? A. Change frequency slightly B. Decrease the squelch setting C. Turn on the noise blanker D. Use the RIT control The correct answer is C. Question 6 Which of the following controls could be used if the voice pitch of a single-sideband signal seems too high or low? A. The AGC or limiter B. The bandwidth selection C. The tone squelch D. The receiver RIT or clarifier The correct answer is D. Question 7 What does the term "RIT" mean? A. Receiver Input Tone B. Receiver Incremental Tuning C. Rectifier Inverter Test D. Remote Input Transmitter The correct answer is B. Question 8 What is the advantage of having multiple receive bandwidth choices on a multimode transceiver? A. Permits monitoring several modes at once B. Permits noise or interference reduction by selecting a bandwidth matching the mode C. Increases the number of frequencies that can be stored in memory D. Increases the amount of offset between receive and transmit frequencies The correct answer is B. Question 9 Which of the following is an appropriate receive filter bandwidth to select in order to minimize noise and interference for SSB reception? A. 500 Hz B. 1000 Hz C. 2400 Hz D. 5000 Hz The correct answer is C. Question 10 Which of the following is an appropriate receive filter bandwidth to select in order to minimize noise and interference for CW reception? A. 500 Hz B. 1000 Hz C. 2400 Hz D. 5000 Hz The correct answer is A. Question 11 Which of the following describes the common meaning of the term "repeater offset"? A. The distance between the repeater's transmit and receive antennas B. The time delay before the repeater timer resets C. The difference between the repeater's transmit and receive frequencies D. Matching the antenna impedance to the feed line impedance The correct answer is C. Question 12 What is the function of automatic gain control or AGC? A. To keep received audio relatively constant B. To protect an antenna from lightning C. To eliminate RF on the station cabling D. An asymmetric goniometer control used for antenna matching The correct answer is A.